Delta Electronics Ethernet Extension Module DOP Dokumentacja Pobierz pdf (Strona 164)

Appendix A Com m unic ation Sett i n g

A-1 3

(5) If the connection type that the driver uses is Ethernet or DirectLink (Ethernet), the users have to

select an IP address created in COMMGR in the IP Address drop-down list box.

(6) After the setting is complete, users can click OK. The information about the driver which is

connected is displayed in the status bar.

A.1.6 Connecting a PLC and a Communication Port

After all setting is complete, users can connect a PLC to a communication port specified through a

communication cable. Some common ways to connect a PLC to a communication port, and some

points for attention are listed below. Please refer to PLC manuals for more information about

connecting PLCs to communication ports.

1. DVP series PLC (RS232)

A computer is connected to a DVP series PLC through a Delta communication cable. The

connection type that a driver uses is RS232.

Note:

Users have to make sure that the communication protocol for exchanging data through a

driver is the same as the communication protocol for exchanging data through a

communication port on a PLC before they connect the driver to the PLC.

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 174 175

Brak uwag

Delta Electronics Ethernet Extension Module DOP Dokumentacja Strona 164